274,298 – 252,355
5-10 meters metal detector waterproof Pin Probe
Press and release button while holding the detector away from any metallic objects. You will hear 1 beep and LED Flashlight will remain on.
Press and release the button to power off.
The white LED will remain illuminated while the unit is on, providing power-on indication and acting as a flashlight when needed.
The Pin Probe has three alarm modes.
Audio(Default),Vibration, Audio and Vibration
at the same time.Press Power ON/OFF switch to select needing detection mode.
Lost Pin Probe Alarm
After 5 minutes of being ON without a button press, Pin Probe will begin emitting progressively faster warning chirps for 10 seconds.
This rugged edge is ideal for sifting through dirt while searching for the target.
Pin Probe 360-side-scan detection allows the detector to alarm when the unit is passed in close proximity to a metallic target.
Secure to any standard size belt. A metal snap within the holster will cause the Pin Probe to alarm if put away while powered on.
Low Battery Alarm
When the battery becomes low, the detector will sound warning alarm. And check distance will short.Replace the 9V battery as soon as possible.
Simply rotate the battery cover counterclockwise to remove and clockwise to tighten by hand. To properly install the 9V battery, match the larger battery terminal to the larger opening in the compartment.
Remove the battery when the unit is to be stored more than 30 days.
Operating Frequency: 12 kHz
Indicators: Audio,Vibration and Audio and Vibration at the same time
Control: Power switch
Dimensions: Length: 26.5cm
Battery: Single 9V (not included)